How To Replace Upper Control Arm Chevy Silverado

How to Supersede the Pitman Arm in a Chevy Truck

by Russell Wood

simplytheyu/iStock/Getty Images

There are a few dissimilar types of steering out at that place, and i of the older models is known as recirculating ball steering. The steering wheel is connected to a steering box, which transfers motility through the pitman arm to the steering linkage, which turns the wheels. If the pitman arm wears out, you'll accept sloppy steering, which can be dangerous. Replacing the pitman arm on a Chevrolet truck is not a lot of fun, simply it can be done at habitation with the right tools in about an 60 minutes.

Step 1

Lift upwardly the front of the vehicle using the jack and secure it on jack stands. Make sure the vehicle is completely secure on the jack stands earlier you clamber underneath it. Also brand sure the wheels are pointed straight.

Pace ii

Locate the steering gear box on the truck. It's on the driver's side frame rail and has a dog-legged arm that comes off of it which is the pitman arm. Make an alignment marker across the pitman arm and the steering gear shaft, using a paint marking.

Step 3

Remove the cotter pin from the ball joint stud on the opposite end of the pitman arm. Remove the nut with a box-end wrench. Remove the Nut on the on the steering gear shaft with a billow bar and socket.

Pace 4

Place the pitman arm puller tool on the pitman arm so that the center commodities is on the middle of the shaft and the hooks on the side of the tool slide behind the pitman arm. Tighten the center commodities to pull the pitman are off of the steering gear shaft.

Pace 5

Hold the old pitman arm adjacent to the new pitman arm and transfer the paint line measurement to the replacement arm using the paint marking.

Step 6

Line up the replacement pitman arm on the gear according to the marked line and printing information technology into place. Install the nut and tighten it to specifications -- by and large this is 184 foot-pounds on clamp-blazon pitman arms, and 125 pes-pounds if information technology is secured by a nut.

Pace 7

Bolt the ball joint on the pitman arm to the steering linkage, tighten the nut, so install the cotter pivot. Curve the legs of the cotter pivot in opposite directions effectually the ball articulation stud.

Lift the vehicle off of the jack stands with the jack and place information technology on the ground. Take the vehicle to a local store to take a forepart alignment completed.

Things You'll Need